Monday, March 30, 2015

If the condition of the thermostat and waterpump in good condition but still above normal temperatu


Otomotrip.com - The function of the thermostat on the engine radiator cool room panels for sale water circulation - circulation system car engine cooling system with water or coolant medium can be classified into two short circulation and long circulation.
In general, the working temperature cool room panels for sale of the engine, where the machine can work optimally range between 80-90 C when measured at a temperature in the engine oil and is in the range of 85-95 C when the measured cool room panels for sale temperature of the engine through the radiator cap opening or temperature read by the ECU through engine cooling water temperature sensor.
Thermostat can open and close as wax sealed contained in the cylinder thermostat, wax volume cool room panels for sale can be increased cool room panels for sale when the temperature rises, it will open the thermostat valve, and vice versa if the temperature dropped wax volume will be reduced and the thermostat valve is closed.
It could be concluded that the function Thermostat In Engineering is to maintain the working temperature of the machine by opening and closing the radiator water channels in accordance temperature cool room panels for sale indicated on the thermostat body.
When a new car engine is turned on the water in the radiator temperature range at room temperature is about 23 C. When the machine is turned on, the water inside the engine block with the help waterpump or circulating water pump by-pass through tubes or channels baypass without passing through the radiator.
Why not pass through the radiator? That is because the water into the radiator hole is still closed by a thermostat, while the by-pass hole that is located opposite the open hole into the radiator allows waterpump drain water out of the engine cool room panels for sale block to get back into the engine to cool the cylinder block, cylinder head and oil cooler .
When the engine reaches operating temperature, the water temperature in the circulation system of the cooling phase was increased cool room panels for sale up to 85-90 degrees Celsius. When the water temperature up to the house thermostat, cool room panels for sale thermostat which by the manufacturer cool room panels for sale are set to open at a temperature between 85-90 degrees celsius open.
Thus allowing water from entering the engine cool room panels for sale block to the radiator or water from the radiator into the engine block depending on the placement of the thermostat if the thermostat cool room panels for sale is placed before or after the radiator radiator.
Then waterpump pumping cool room panels for sale water from the radiator to keep the working temperature of the engine. The water coming out of the engine block into the radiator to be cooled with the help of the wind from the fan or fan radiator, both mechanically and electrically. Removing Air Circulation Radiator Thermostat On
Indication of the thermostat has been unable to work optimally or to be replaced is the engine temperature rises higher than normal temperature when seen from the temperature indicator on the panel of the vehicle speedometer.
Removing the thermostat from the radiator water circulation system is not a wise move because the thermostat mengilangkan as a regulator of circulating water in the cooling system, circulating water will run is not perfect.
Without a thermostat, the temperature reached the machine work longer, heating phase and cooling phase does not occur, because the engine temperature is still cold, the water has entered into the radiator, when the water temperature not need to be refrigerated.
When the water is boiling, the thermostat must be open, if not means it can not be used anymore. And better also use a thermometer to see if the thermostat opening temperature according to the numbers listed on the body temperature of the thermostat. Signs waterpump Damaged Cars
For water pump, if it appears there was a trickle of water from a hole under the axle pulley, cool room panels for sale it is an early sign that the waterpump damaged. Other damage to the waterpump cool room panels for sale is sounded when the engine is rotating. Waterpump damaged can not be repaired, it must be replaced with new ones.
If the condition of the thermostat and waterpump in good condition but still above normal temperatures, likely radiators are not working properly. That the possibility of a blockage in the drain water in the radiator. To this can be seen in the engine cooling system treatments.
tags: How to Work Thermostat Engine, Symptoms Damage Water Pump, Thermostat Symptoms Damaged Engine, Cooling System Car Engine Related For Function cool room panels for sale and How it Works Water Circulation Radiator Thermostat On Cars
Radiator Coolant Water Prevents Brittle Machine May 28th 2013 | Cooling System Otomotrip.com - Function Radiator coolant in the engine radiator water is as coolant to keep the engine temperature cool room panels for sale remains
Tips to Detect Damage Leaking Radiator Before March 28th 2013 | Cooling System cool room panels for sale Detecting early before leaking radiator includes important to prevent leaks in the radiator when we were on the way.
Analysis, Influence and Effect Removing Thermostat From Car Engine August 10th 2013 | Cooling System Otomotrip.com - Analysis, Influence cool room panels for sale and Impact or result

No comments:

Post a Comment